Omtech POLAR+ User Manual page 60

6 Operation
3. Confirm the thickness of your material with the provided ruler and place a sample piece into the
main bay.
The standard location is in the top right corner of the workbed. This can be changed by moving
either your design or the origin position in your software.
For Pieces No Longer Than 20 inches (510 mm)
Thickness
≤ 17 mm
17 mm–51 mm
Instructions
Directly put the sample piece on the honeycomb workbed.
1. Open the tray, remove the honeycomb workbed, and then close the
tray.
2. Put the sample piece on the tray.
53