Changes To Figure 12; Changes To Reset Function Section; Change To Figure 14; Changes To Voltage Display Function And Figure 16 - Analog Devices ADMX3652 User Manual

User Guide
MODULE OPERATION
Basic Functions
After establishing the connection between the
ADMX3652 Evaluation GUI Software
activate and then allow operation by the user.
Connect or Disconnect Function
After a connection to the ADMX3652 is established, the Connect
button changes to Disconnect. Click Disconnect to disconnect the
communication between the ADMX3652 Evaluation GUI Software
tool and the ADMX3652. Once disconnected, all settings are disa-
bled and can no longer be changed.
Figure 12. Connect or Disconnect Function
Reset Function
In the connection state, click Reset for the ADMX3652 Evaluation
GUI Software tool to send a command of *RST (see
the device to set it to the default factory settings. Once the device
resets, users see a loading circle, and the settings are disabled.
Figure 13. Reset Function
Setting the Power Line Frequency Function
Set the power line frequency according to the standard AC line
frequency. This setting depresses normal mode noise from the
power line frequency. Select the correct frequency according to the
location of the device.
analog.com
ADMX3652 and the
tool, the functions of the tool
Table 1) to
Figure 17. Status Bar Function
EVAL-ADMX3652
Note that the power line frequency is set to 50 Hz by default.
Figure 14. Power Line Frequency Setting
Light and Dark Mode Function
The user interface can be set according to the preference of the
user.
Figure 15. Light and Dark Mode Function
Voltage Display Function
The measured voltage displays in the Voltage Display boxes. The
box displays as dash lines before any actual measurements. When
the measured voltage is more than 10% tolerance of the measuring
range, it displays as OVERLOAD.
Figure 16. Voltage Display Boxes
Status Bar Function
The status bar displays dynamically the current status of the
ADMX3652 Evaluation GUI Software tool, for example, connect-
ed, disconnected, measurement done, and so on.
Rev. B | 10 of 22