AJAX KeyPad Plus User Manual page 7

3. Make sure that the hub is not in armed mode and does not start updates by
checking its status in the app.
Only a user or PRO with full admin rights can add a device to the hub.
To connect KeyPad Plus
1. Open the Ajax app. If your account has access to multiple hubs, select the one to
which you want to connect KeyPad Plus.
2. Go to the Devices
3. Name the keypad, scan or enter the QR code (located on the package and under
the SmartBracket mount), and select a room.
4. Click Add; the countdown will begin.
5. Turn on the keypad by holding the power button for 3 seconds. Once connected,
KeyPad Plus will appear in the hub device list in the app. To connect, locate the
keypad at the same protected facility as the system (within the coverage area of
the hub radio network range). If the connection fails, try again in 10 seconds.
The keypad only works with one hub. When connected to a new hub, the device stops sending
commands to the old hub. Once added to a new hub, KeyPad Plus is not removed from the
device list of the old hub. This must be done manually through the Ajax app.
KeyPad Plus turns off automatically 6 seconds after being turned on if the keypad
fails to connect to the hub. Therefore, you do not need to turn off the device to retry
the connection.
Updating the statuses of devices in the list depends on the Jeweller settings; the
default value is 36 seconds.
Icons
The icons represent some of KeyPad Plus states. You can see them in the Devices
tab in the Ajax app.
menu and click Add Device.