Before Operation; Setting The Clock - Aiwa Z-R325 Operating Instructions Manual

BEFORE OPERATION SETTING THE CLOCK
DEMO
POWER
CLEAR
CD
To turn the unit on
Press the POWER button.
,... - — -..., J
@
SHIFT
FUNGTION
The disc compartment may open and close to reset the unit.
After use
Press the POWER button to turn off the power. The display
changes to clock.
DEMO (Demonstration) mode
After connecting the AC cord, the display window demonstrates
the functions of the unit. When the power is turned on, the DEMO
display is overridden by the operation display. When the power
is turned off, the DEMO mode is restored.
To cancel DEMO mode
Press the DEMO button. To re-activate, press again.
Flash window
The window on the top of the unit lights up or flashes while the
unit is being powered on.
To turn off the light, press the CLEAR button on the main unit
while pressing the CD button.To turn back on, repeat the above.
To use the SHIFT button on the remote control
Buttons @ have two different functions. One of these functions
is indicated on the button, and the other on the plate above the
button.
To use the function on the button, simply press the button.
To use the function on the plate above the button, press the
button while pressing the SHIFT button.
To use the FUNCTION button on the remote control
The FUNCTION buttonsubstitutes
for the function buttons (TAPE,
TUNER/BAND, PHONO/VIDEO/AUX, CD) on the main unit.
Each time the FUNCTION button is pressed, the next function is
selected cyclically.
EEE3
If the remote control is not going to be used for an extended
period of time, remove the batteries to prevent possible
electrolyte leakage.
The remote control may not operate correctly when:
- The line of sight between the remote control and the remote
sensor inside the display window is exposed to intense light,
1,3,5
2,4
Set
the time as follows while the power is off.
1
2
3
4
5
Press the 11 SET button.
The hour flashes.
Press the l++ DOWN or M UP button
designate the hour.
Press the II SET button to set the hour.
The hour stops flashing and the minute starts flashing.
Press the 1++ DOWN or *I UP button
designate the minute.
to
to
Press the 11 SET button to set the minute and
complete setting.
The minute stops flashing on the display and the clock starts
from 00 second.
To
correct the current time
Press the POWER button to turn the unit off. Press the II SET
button and carry out steps 1 to 5 above.
To display the current time
Press the CLOCK button while pressing the SHIFT button on
the remote control. The clock is displayed for 4 seconds.
However, the time cannot be displayed during recording.
To
switch to the 24-hour standard
Press the CLOCK button while pressing the SHIFT button on
the remote control and then press the CLEAR button within 4
seconds.
Repeat the same procedure to restore the 12-hour standard.
If the clock display flashes
This is caused by a power interruption. The current time needs
to be reset.
If power is interrupted for more than approximately 24 hours,
all settings stored in memory after purchase need to be reset.
such as direct sunlight
- Other remote controls are used nearby (those of a television,
etc.)
ENGLISH
4