Setting The Sleep Timer; Optional Equipment - Aiwa Z-R325 Operating Instructions Manual

SETTING THE SLEEP TIMER
OPTIONAL EQUIPMENT
The unit can be turned off automatically at a specified time,
Use the remote control.
1
Press the SLEEP button while pressing the SHIFT
button.
2 Within 4 seconds, press the ~ or ~ button
to specify the time until the power is turned off.
Each time the button is pressed, the time changes between 5
and 240 minutes in 5-minute steps.
Specified time
To check the time remaining until the power is turned off
Press the SLEEP button once while pressing the SHIFT button.
The remaining time is displayed for 4 seconds.
To cancel the sleep timer
Press the SLEEP button twice while pressing the SHIFT button
so that "SLEEP on the display disappears.
L OUT
EO/AUX IN
Refer to the operating instructions of the connected equipment
for details.
The connecting cords are not supplied. Obtain the necessary
connecting cords.
Consult your local Aiwa dealer for optional equipment.
CONNECTING PHONO/VIDEO/AUX IN
JACKS
Instead of connecting to the supplied turntable, this unit can also
connected to other optional audio equipment with analog sound
signals output (LD player, VCR, TV, etc.).
Use a cable with RCA phono plugs to connect the equipment.
Connect the red plug to the R jack, and the white plug to the L
jack.
When connecting a turnable other than the supplied one
Use an Aiwa turntable equipped with a built-inequalizer amplifier.
CONNECTING CD DIGITAL OUT (OPTICAL)
JACK
This unit can output CD digital sound signals through this jack.
Use an optical cable to connect digital audio equipment (digital
amplifier, DAT deck, MD recorder, etc.).
Remove the dust cap @) from the CD DIGITAL OUT (OPTICAL)
jack. Then, connect an optical cable plug@ to the CD DIGITAL
OUT (OPTICAL) jack.
When the CD DIGITAL OUT (OPTICAL) jack is not being
used
Attach the supplied dust cap.
LISTENING TO EXTERNAL SOURCES
To play equipment connected to the PHONO/VIDEO/AUX IN
jacks, proceed as follows.
1 Press the PHONO/VIDEO/ALIX button.
PHONO appears on the display.
2 Play the connected equipment.
To change a source name in the display
When the PHONO/VIDEO/AUX button is pressed, PHONO is
displayed initially. It can be changed to VIDEO, AUX or TV.
With the power on, press the POWER button while pressing the
PHONO/VIDEO/AUX button.
Repeat the procedure until the desired name appears on the
display.
ENGLISH 14