Table of Contents
Advertisement
POWER
Al
POWER
—y
SET
16
PREPARATIONS
BEFORE OPERATION
To turn on the unit — EY
Press the POWER button.
You can also turn the unit on by, pressing-one of the direct play
buttons. (See page 18.)
After use
Press the POWER
button to turn off the power. The display
changes to clock or DEMO mode.
For 4 seconds after turning on the unit
The most recently used function button flashes.
No operation may be carried out during this period.
Illumination guide — E]
Whenever one of the function buttons is pressed, the buttons for
that operation light up or flash.
Example:
When connecting the AC cord, the If SET button flashes to guide
you in setting the current time.
Headphones
Connect headphones to the PHONES jack with a stereo standard
plug (96.3 mm/"/ inch).
No sound is heard from the speakers while headphones are
plugged in.
After a power interruption
The current time needs to be reset. (See page 20.)
* If power is interrupted for more than about 24 hours, you will also
have to reset preset stations and timer playback or recording
settings.
CASSETTE TAPES
Usable tapes
For playback, use normal (type I), CrOz (type II), and metal (type
IV) tapes.
For recording, use normal (type I) and CrOz (type II) tapes.
The proper bias and equalization to suit the type of tape are
selected automatically.
Tape slack
Take up any slack in the tape with a pencil or similar tool before use.
Slack tape may break or jam in the mechanism. —
120-minute or longer tapes
These are extremely thin and easily deformed or damaged. They
are not recommended.
To prevent accidental erasure
Break off the plastic tabs on the cassette tape after recording, with
a screwdriver or other pointed tool.
-
@ Side A
@ Tab for side A
To record on the tape again, cover the tab openings with cello-
phane tape. (On CrOz tapes, take care not to cover the ¢rOz tape
detection slot @.) - &
Advertisement
Table of Contents
