Programmed Play - Aiwa Z-R325 Operating Instructions Manual

To check the remaining time
During play, press the EDIT/CHECK button while pressing the
SHIFT button on the remote control. The amount of time
remaining until all tracks finish playing is displayed. To restore
the play time display, repeat the above again.
m
When loading an 8-cm (3-inch) disc, make sure to put it onto
the inner circle of the tray precisely. Otherwise, the disc may
be damaged or the disc compartment will not open. If it does
not open, please consult your Aiwa dealer for repair.
Do not place more than one compact disc on one disc tray.
Do not tilt the unit with discs loaded. Doing so may cause
malfunctions.
When transporting the unit, remove the discs from the trays.
When replacing the discs during play, do not replace discs other
than those facing you.
If you place a disc on the empty right inner tray, and then press
the A OPEN/CLOSE button, "ERROR is displayed and the disc
compartment may not close. Remove the disc on that tray.
RANDOM /REPEAT PLAY
Use the remote control.
RANDOM play
All the tracks on the selected disc or on all the discs can be
played randomly.
REPEAT play
All the tracks on the selected disc or on all the discs can be
played repeatedly.
Press the RANDOM/REPEAT button while pressing the
SHIFT button.
Each time they are pressed, the function can be selected
cyclically.
@ RANDOM play
@ REPEAT play
@ RANDOM/REPEAT play
@ Cancel
m
. Even if the + button is pressed during RANDOM play, a
previously played track cannot be skipped. The unit returns to
the beginning of the current track only.
. Direct selection of the tracks with the numeric buttons is not
possible during RANDOM play.
PROGRAMMED PLAY
up to 30
discs.
tracks can be programmed from any of the inserted
Use the remote control.
1
2
3
Press the PRGM button while pressing the SHIFT
button in stop mode.
The PRGM indicator is displayed.
Press one of the DISC DIRECT PLAY buttons to
select a disc.
To select disc 4 or 5, press DISC DIRECT PLAY 4 or 5 button
while pressing the SHIFT button.
The selected disc is indicated in red on the display.
Go to the next step when the tray stops rotating.
Press the numeric buttons and the +10 button to
program a track.
Example:
To select the 25th track, press the +10, +10 and 5 buttons.
To select the 10th track, press the +1 O and O buttons.
Total playing time of
Program n;mber the selected tracks
Selected track nu~ber Total number of selected tracks
4 Repeat steps 2 and 3 to program other tracks.
5 Press the > button to start play.
To
check the program
Each time the - or * button is pressed in stop mode, a
disc number, track number, and program number will be
displayed.
To clear the program
Press the CLEAR button in stop mode.
To
add tracks to the program
Before playing, repeat steps 2 and 3. The track will be
programmed after the last programmed track.
To
change the programmed tracks
Clear the program and repeat all the steps again.
Em3
RANDOM play is not performed during programmed play.
During the programmed play, the EDIT/CHECK, DISC
CHANGE, DISC DIRECT PLAY 'and numeric buttons do not
ENGLISH
8