Sound; Simple Audio Adjustment - Aiwa Z-R325 Operating Instructions Manual

SIMPLE AUDIO ADJUSTMENT
ROCK,
POP,
JAZZ
PHONES
VOLUME
T-BASS
GEQ
T-BASS
SHIFT
VOLUME
VOLUME CONTROL
Turn the VOLUME control on the main unit, clockwise to
increase the volume and counterclockwise to decrease it.
The
volume level is shown on the display for 4 seconds. It can
be set between O and MAX (31).
The volume remains memorized even after the power is turned
off. However, if the power is turned off when the volume is set to
more than 16, it is automatically set to 16 the next time the power
is turned on.
To adjust with the remote control, press the VOLUME
buttons.
m
The volume is automatically set to 10 after the unit was reset
(See page 15).
SUPER T-BASS SYSTEM
The T-BASS system enhances the realism of low-frequency
sound.
Press the T-BASS button on the main unit.
Each time it is pressed, the level changes. Select one of the
three levels, or the off position to suit your preference.
1 \\ \\\
\\\~'
T-BASS + T-BASS + T-BASS+
T-BASS J
(cancel)
To select with the remote control
Press the T-BASS button while pressing the SHIFT button.
GRAPHIC EQUALIZER
This unit provides the following three different equalization curves.
ROCK:
Powerful sound emphasizing treble and bass
POP:
More presence in the vocals and midrange
JAZZ: Suppressed vocals range appropriate for listening
to rhythmical sources
Press one of the graphic equalizer buttons (ROCK, POP,
JAZZ).
The selected equalizer mode appears on the display.
To cancel the selected mode
Press the selected button again. "GEQ OFF is displayed.
To select
with the remote control
Press the GEQ button repeatedly while pressing the SHIFT
button. The GEQ mode is displayed cyclically as follows.
r
ROCK + POP + JAZZ + GEQ OFF
(cancel)
1
W&Mta
Low frequency sound may be distorted when the T-BASS system
is used for a disc or tape in which low frequency sound is originally
emphasized. In this case, cancel the T-BASS system.
Sound adjustment during recording
The output volume and tone of the speakers or headphones
may be freely varied without affecting the level of the recording.
Using the headphones
Connect headphones to the PHONES jack with a stereo standard
plug (06.3 mm,
'/4
inch).
No sound is output from the speakers while the headphones are
plugged in.
5
ENGLISH