Before Operation - Aiwa Z-L520 Operating Instructions Manual

Inserting batteries
Detach the battery cover on the rear of the remote control and
insert two R6 (size AA) batteries.
R6(AA)
When to replace the batteries
The maximum operational distance between the remote contro!
and the sensor on the main unit should be approximately 5 meters
(16 feet). When this distance decreases, replace the batteries
with new ones.
To use SHIFT on the remote control
Buttons @ have two different functions. One of these functions
is indicated on the button, and the other on the plate above the
button.
To use the function on the button, simply press the button.
To use the function on the plate above the button, press the button
while pressing SHIFT.
To use FUNCTION on the remote control
FUNCTION substitutes for the function buttons (TAPE/DECK 1/2,
TUNER/BAND, VIDEO/AUX/PHONO, CD) on the main unit.
Each time FUNCTION is pressed, the next function is selected
cyclically.
FUNCTION
* If the remote control is not going to be used for an extended
period of time, remove the batteries to prevent possible
electrolyte leakage.
* The remote control may not operate correctly when:
- The line of sight between the remote control and the remote
sensor inside the display window is exposed to intense light,
such as direct sunlight.
- Other remote controls are used nearby (those of a television,
etc.).
BEFORE OPERATION
ECO
POWER ENTER
® STANDBY/ON
MULTI
JOG
To turn the power on
Press one of the function buttons (TAPE/DECK 1/2, TUNER/
BAND, VIDEO/AUX/PHONO or CD).
Playback of the inserted disc or tape begins, or the previously
tuned station is received (Direct Play Function).
POWER is also available.
When the unit is turned on, the disc compartment may open and
close to reset the unit.
To turn the power off
Press POWER STANDBY/ON
Illumination guides
Whenever POWER or one of the function buttons is pressed,
the buttons for the selected operation light up or flash.
Example: When CLOCK is pressed, IISET, << and >» light
up as a guide to setting the current time. i
To change the brightness level of the display
1 Press ECO twice so that "DIM MODE' is displayed.
2 Within 4 seconds, press ENTER.
3 Within 4 seconds, turn MULTI JOG to select the dimmer mode
as below.
[° DIM-OFF <—>DIMMER 1<—> DIMMER 2<—> DIMMER al
"DIM OFF" mode is the brightest and "DIMMER 3" mode is
the dimmest.
In "DIMMER 3" mode, the spectrum analyzer, and the button
illumination light off in addition.
4 Within 4 seconds, press ENTER to set the selected mode.
ENGLISH 5