Programmed Edit Recording - Aiwa Z-R325 Operating Instructions Manual

PROGRAMMED EDIT RECORDING
The programmed edit function enables CD recording while
checking the remaining time on each side of the tape as the
tracks are programmed.
2
2
1
8J0
5
4
3,7,8,9
5
3,5,7,
8,9
1
2
3
4
Insert the tape into deck 1 and wind up to the
beginning of the front side.
Insert the tape with the side to be recorded first facing out
from the unit, and wind up the tape with the + button.
Press the CD button and load the disc(s).
Press the EDIT/CHECK button twice while
pressing the SHIFT button on the remote control.
PRGM and EDIT are displayed.
Press the numeric buttons on the remote control
to designate the tape length.
10 to 99 minutes can be specified.
Example: When using a 60-minute tape, press the 6 and O
buttons.
Maximum recording
Tape length
time for side A
Tape side A (front side)
5 Press one of the DISC DIRECT PLAY buttons to
select a disc and press the numeric buttons to
program a track.
To select disc 4 or 5 from the remote control, press the DISC
DIRECT PLAY 4 or 5 button while pressing the SHIFT button.
Example: To select the 10th track of disc 2, press DISC
DIRECT PLAY 2 and the numeric buttons + 10 and O.
Repeat step 5 for the rest of the tracks for side
A.
A track whose playing time is longer than the remaining time
cannot be programmed.
Remaining time
Programmed
of side A tracks
7
8
9
Total number of
programmed tracks
Press the EDIT/CHECK button while pressing the
SHIFT button to select side B and program the
tracks for side B.
After confirming B on the display, repeat step 5.
Press the EDIT/CHECK button while pressing the
SHIFT button to select side A and press the
button on deck 1 to start recording.
~
flashes for 10 seconds, and then CD play and recording
of edited tracks for the first side start simultaneously. When
the end of the tape is reached, deck 1 enters the recording
stop mode. After entering the recording stop mode, go to
step 9.
Press the EDIT/CHECK button while pressing the
SHIFT button on the remote control for recording
of the second side.
After confirming Bon the display, go to step 10.
10 Turn over the tape in deck 1 and press the
button.
To
stop recording
Press the W= button on deck 1. Recording and CD play stop
simultaneously.
To check the order of the programmed track numbers
Before recording, press the EDIT/CHECK button while pressing
the SHIFT button to select side A or B, and press the M DOWN
or -UP button repeatedly.
Programmed track
Disc number
Program number
numbers
,
Tape side
Track number
To change the program of each side
Press the EDIT/CHECK button while pressing the SHIFT button
to select side A or B, and press the CLEAR button to clear
the program of the selected side. Then program tracks again.
To clear th~edited program
Press the WCLEAR button twice in stop mode so that EDIT
disappears on the display.
11
ENGLISH