Setting The Clock; Setting The Sleep Timer - Aiwa NSX-S505 Operating Instructions Manual

SETTING THE CLOCK
ao i) ne
MULTI JOG
1 Press CLOCK once, then press Il SET within 4
seconds.
When using the remote control
Press CLOCK while pressing SHIFT, then press If SET within
4 secon
2 Press << DOWN or > UP to designate the
hour, then press Hf SET.
The hour stops flashing and the minute starts flashing.
3 Press << DOWN or »» UP to designate the
minute, then press Il SET.
The minute stops flashing on the display and the clock starts
from 00 seconds.
To display the current time
'Press CLOCK. The time is displayed for 4 seconds.
However, the time cannot be displayed during recording.
To switch to the 24-hour standard
Press the CLOCK and then press ll within 4 seconds.
Repeat the same procedure to restore the 12-hour standard.
If the clock display flashes
This is caused by a power interruption. The current time needs
to be reset.
lf power is interrupted for more than approximately 24 hours,
all settings stored in memory after purchase need to be reset.
* MULTI JOG is also available instead of << and PP.
* ENTER is also available instead of If SET.
25 ENGLISH
SETTING THE SLEEP TIMER
The unit can be turned off automatically at a specified time.
Use the remote control.
1 Press SLEEP while pressing SHIFT.
2 Within 4 seconds, press << or > to specify
the time until the power is turned off.
Each time the button is pressed, the time changes between 5
and 240 minutes in 5-minute steps.
Specified time
To check the time remaining until the power is turned off
Press SLEEP once while pressing SHIFT. The remaining time is
displayed for 4 seconds.
To cancel the sleep timer
Press SLEEP twice while pressing SHIFT so that "SLEEP oFF"
appears on the display.
* MULTI JOG is also available instead of << and >>.