Table of Contents
Advertisement
5 Press the POWER button to turn the unit off after
adjusting the volume.
©® remains on the display after the power is turned off (timer
standby mode).
—
When the timer-on time is reached, the unit turns on and
begins play with the selected source.
To check the specified time
Press the TIMER button on the remote control. The timer-on
time flashes for 4 seconds.
However, the duration for the timer-
activated period will not be displayed.
To cancel timer standby mode temporarily
Press the TIMER button on the remote control twice to tum off ©.
Using the unit while the timer is set
You can use the unit normally after setting the timer.
Before turning off the power, repeat step 4 to prepare the source,
and adjust the volume.
* Timer playback will not begin unless the power is turned off.
* Connected equipment cannot be turned on and off by the built-
in timer of this unit. Use an external timer.
* When power is interrupted, © display disappears and the clock
flashes. Reset the clock and set the timer again.
SETTING THE SLEEP TIMER
The unit can be turned off automatically at a specified time.
Preparation
Make sure the clock is set correctly.
Use the remote control.
1 Press the SLEEP button.
S{SLEEPE,
2 Within 4 seconds, press the k¢< or >>I button
to specify the time until the power is turned off.
[at
Each time the button is pressed, the time changes between 5
and 240 minutes in 5-minute steps.
Specified time
To check the time remaining until the power is turned off
Press the SLEEP button once. The remaining time is displayed
for 4 seconds.
To cancel the sleep timer
Press the SLEEP button twice until "SLEEP" on the display
disappears.
If the unit is turned off during tape playback, the B» PLAYpbutton
will not be released. Press the M/& button to release [ne >
PLAY button.
-ENGLIS# 14
Advertisement
Table of Contents
