Setting The Sleep Timer - Aiwa XR-M99 Operating Instructions Manual

7 Press the POWER button to turn the system off
after adjusting the volume and tone.
© or © GH remains on the display after the power is turned
off (timer standby mode).
Note, however, that everything on the display will clear if the
power economizing mode (see page 9) is activated. To confirm
the timer standby mode, turn on the system and press the
ECO button to deactivate the power economizing mode, i.e.,
select "ECO OFF,' then turn off the system again.
&
i
When the timer-on time is reached, the unit turns on and
begins play (or recording) with the selected source.
If the volume level was set to higher than 21 when the power
was turned off, it is automatically set to 21 when the system
turns on by the timer.
However, when the power economizing mode (page 9) has
been turned on, sound will not be heard during timer recording.
To monitor the sound being recorded, deactivate the power
economizing mode.
To check the specified time and source
Press the JOG MODE button again and display the timer mode
you have selected, then press the ENTER/ILLUMINATION button.
The selected source name, the timer-on time and the duration
for the timer-activated period are displayed. Press the JOG MODE
button to return to the previous display.
To change the timer setting
Set the timer again from the beginning.
To cancel timer standby mode temporarily
Press the JOG MODE button to display the timer mode, then
turn the VOLUME/MULTI JOG dial to display "TIMER OFF." And
then press the ENTER/ILLUMINATION button within 6 seconds.
To restore the timer standby mode, select "TIMER © REC" or
"TIMER © PLAY' instead of "TIMER OFF"
Using the system while the timer is set
You can use the system normally after setting the timer.
Before turning off the power, repeat step 6 to prepare the source
and the recording destination, and adjust the volume and tone.
+ Timer play and timer recording will not begin unless the power
is turned off.
* Connected equipment cannot be turned on and off by the built-
in timer of this system. Use an external timer.
SETTING THE SLEEP TIMER
et
H
JOG MODE
VOLUME/
MULTI JOG
The system can be turned off automatically at a specified time.
1 Press the JOG MODE bution repeatedly so that
EP OFF" is displayed.
2 Within 6 seconds, turn the VOLUME/MULTI JOG
dial or press the << or > button on the remote
control to specify the time until the power is
turned off.
Each time the button is pressed, the time changes between 5
and 240 minutes in 5-minute steps.
Specified time
To check the time remaining until the power is turned
off
Press the JOG MODE button repeatedly so that "SLEEP xx" (xx
is the time until the power is turned off.) is displayed. The
remaining time is displayed for 6 seconds.
To cancel the sleep timer
Press the JOG MODE button repeatedly so that "SLEEP xx" is
displayed. Then turn the VOLUME/MULTI JOG dial or press the
<4 or &P button on the remote control to display "SLEEP OFF"
The "SLEEP" on the display disappears. :
ENGLISH 35