Programmed Edit Recording - Aiwa Z-L100 Operating Instructions Manual

PROGRAMMED EDIT RECORDING
DISC
DIRECT
PLAY 1-3
45
3,7,8,9
In the programmed edit recording function the tracks can be
programmed while checking the remaining time on.each side of
the tape as the tracks are programmed.
7 Insert the tape into deck 1.
Insert the tape with the side to be recorded on first facing out
from the unit, and wind up the tape with <<.
2 Press CD and load the disc(s).
3 Press CD EDIT/CHECK twice while pressing
SHIFT on the remote control.
"EDIT" and "PRGM" are displayed.
«When "Al" is displayed, press CD EDIT/CHECK while
pressing SHIFT again.
4 Press numbered buttons on the remote control
to designate the tape length.
10 to 99 minutes can be specified.
¢ <4 and > are also available to designate the tape length.
Maximum recording
Tape side A
5 Press one of DISC DIRECT PLAY 1-3 to select a
disc.
Then, press numbered buttons 0-9 and +10 on
the remote control to program a track.
Example: To select the 10th track of disc 2, press DISC
DIRECT PLAY 2, then press +10 and 0.
Selected disc Selected track
number number Programmed track number
Program number
Remaining time on side A
13 ENGLISH
6 Repeat step 5 for the rest of the tracks for side
A.
A track whose playing time is longer than the remaining time
cannot be programmed.
7 Press CD EDIT/CHECK while pressing SHIFT on
the remote control to select side B and program
the tracks for side B.
Tape side B (reverse side)
8 Press CD EDIT/CHECK while pressing SHIFT to
select side A and press @ on deck 1.
flashes for 10 seconds, and then CD play and recording
of edited tracks for the first side start simultaneously. When
the end of the tape is reached, deck 1 enters the recording
stop mode. After entering the recording stop mode, go to
step 9.
9 Press CD EDIT/CHECK while pressing SHIFT on
the remote control for recording of the second
side.
"B" is displayed.
10 Turn over the tape in deck 1 and press @ to start
recording.
Recording starts.
To stop recording
Press M/4 on deck 1. Recording and CD play stop
simultaneously.
To check the order of the programmed track numbers
Before recording, press CD EDIT/CHECK while pressing SHIFT
on the remote control to select side A or B, and press <4 or
PP repeatedly.
Programmed
Disc number track numbers
Track number
Tape side Program number
To change the program of each side
Press CD EDIT/CHECK while pressing SHIFT on the remote
control to select side A or B, and press IICLEAR to clear the
program on the selected side. Then program tracks again.
To clear the edit program
Press IICLEAR twice in stop mode so that "EDIT" disappears
on the display.
¢ Recording is inhibited if the erasure prevention tab for the side
of the tape facing out from the unit is broken off.
¢ Up to 30 tracks can be programmed from any of the inserted
discs.
e "FULL is displayed if you attempt to program more than 30
tracks.