Table of Contents
Advertisement
PROGRAMMED EDIT RECORDING
The programmed
edit function enables CD recording while
checking the remaining time on each side of the tape as the
tracks are programmed.
2
—
era
2
2 oa
17 Insert the tape into deck 1 and wind up to the
beginning of the front side.
Insert the tape with the side to be recorded first facing out
from the unit, and wind up the tape with the <<
button.
2 Press the CD button and load the disc(s).
3 Press the EDIT/CHECK
button twice while
pressing the SHIFT button on the remote control.
PRGM and EDIT are displayed.
4 Press the numeric buttons on the remote control
to designate the tape length.
10 to 99 minutes can be specified.
Example: When using a 60-minute tape, press the 6 and 0
buttons.
Tape length
Tape side A (front side)
Maximum recording
time for side A
5 Press one of the DISC DIRECT PLAY buttons to
select a disc and press the numeric buttons to
program a track.
To select disc 4 or 5 from the remote control, press the DISC
DIRECT PLAY 4 or 5 button while pressing the SHIFT button.
Example: To select the 10th track of disc 2, press DISC
DIRECT PLAY 2 and the numeric buttons + 10 and 0.
6
Repeat step 5 for the rest of the tracks for side
A track whose playing time is longer than the remaining time
cannot be programmed.
Total number of
Programmed
programmed tracks
tracks
Remaining time
of side A
7 Press the EDIT/CHECK button while pressing the
SHIFT button to select side B and program the
tracks for side B.
After confirming B on the display, repeat step 5.
8
Press the EDIT/CHECK button while pressing the
SHIFT button to select side A and press the @
button on deck 1 to start recording.
flashes for 10 seconds, and then CD play and recording
of edited tracks for the first side start simultaneously. When
the end of the tape is reached, deck 1 enters the recording
stop mode. After entering the recording stop mode, go to
step 9.
9
Press the EDIT/CHECK button while pressing the
SHIFT button on the remote control for recording
of the second side.
After confirming B on the display, go to step 10.
10 Turn over the tape in deck 1 and press the @
button.
To stop recording
Press the ll/& button on deck 1. Recording and CD play stop
simultaneously.
To check the order of the programmed track numbers
Before recording, press the EDIT/CHECK button while pressing
the SHIFT button to select side A or B, and press the kK DOWN
or »PIUP button repeatedly.
Disc number
Programmed
track
numbers
To change the program of each side
Press the EDIT/CHECK button while pressing the SHIFT button
to select side A or B, and press the I CLEAR button to clear
the program of the selected side. Then program tracks again.
To clear the edited program
Press the INCLEAR button twice in stop mode so that EDIT
disappears on the display.
14
Advertisement
Table of Contents
