Chapter 3 Powering On/Off Procedure - Acer HDS WMS100 Reference Manual

Chapter 3 Powering On/Off Procedure
The disk drive may emit audible mechanical sounds when the disk drive is started (spun up),
immediately after the subsystem is powered on and powered off (spun down). However, this
does not indicate a problem if the WARNING or ALARM LED of the basic frame is off; you may
use the subsystem.
This section describes power on/off procedures for the following:
WMS100 Rack-Mount Model
WMS100 Floor Model
This chapter provides the information on the Fibre and NAS models. The following table
illustrates the sections that provide the explanation for each model. According to the
customer 's model, please read the required section.
Fibre Model: Connects disk array subsystem to a host computer with Fibre Channel
interface.
NAS Model: Connects NAS Unit connected to disk array subsystem to a host computer
with LAN interface.
Sections
3.1 3.1.1 Subsystem Power On
3.1.2 Subsystem Power Off
3.1.3 Stop/Start/Restart of the NAS OS
3.2 3.2.1 Subsystem Power On
3.2.2 Subsystem Power Off
: The explanation is provided.
—: The explanation is not provided.
Acer | HDS WMS100™ User and Reference Guide
Fibre NAS
−
−
−
35