Table of Contents
Advertisement
System Introduction
Features
This section provides basic information concerning the configuration of your Altos R510 system.
Processor
Single or dual Intel
®
Intel
Hyper-Threading
Supports Extended memory 64bit technology (EM64T)
Chipset
®
Intel
E7320 chipset, including:
• Intel
• Intel
Memory
Six (184-pin) DIMM slots supporting DDR-1 333 MHz memory
2-way memory interleaving supported
Maximun upgrade: 12GB
SDDC (Single Device Data Correction) for memory error detection and correction of any number of
bit failures in a single x4 memory device
Memory sparing technology
When memory sparing is enabled, the spare DIMM will not be detected by OS
The sparing DIMM will be reserved for standby purposes and cannot be accessed by the
system (See the Note below)
NOTE: For example, if six 1GB DIMMs are installed (6GB memory) only 4GB of memory (in Dimm 1B, 1A, 2B,
2A) can be accessed by the system. Memory in DIMM 3B and DIMM 3A would be reserved as spare
DIMMs
CAUTION: When using multiple memory modules it is recommended that you AVOID using modules from
different manufacturers or that run at different speeds from each other.
I/O Control
Front:
One USB 2.0 port
One SVGA video port
Rear:
One USB 2.0 port
Two PS/2 ports (keyboard/mouse)
Two LAN ports (RJ-45)
One SVGA video port
Add-in Card
One low-profile riser slot that supports a riser card capable of supporting upto three low-profile
Chapter 1
®
TM
Xeon
processors with 800 MHz FSB
TM
Technology support
®
E7320 Memory Controller Hub (MCH)
®
6300ESC I/O Controller Hub (ICH)
Chapter 1
1
Advertisement
Table of Contents
