Axis 2N Analog Force Installation Manual page 63

DTMF FUNCTION
Character
These digits are interpreted as a password beginning - for switch control.
to
Notes
These commands do not work in the Automatic Multiple Number Dialling
mode without Confirmation!
The above-mentioned commands
connection if sent during a message. To avoid this, press the button
during the time of silence (between messages).
Survey of Messages
The table below includes a survey of language versions for standard announcements.
English is selected by default. To select another language, use parameters 976 and
977.
Value of Language
parameter selection –
976 English
version
0 Tone signal
1 English
(defaultvalue)
2 German
2N TELEKOMUNIKACE a.s., www.2n.cz
may not be accepted
End of call Outgoing call message
message
ID message.Parameter
975 must contain digit
2, 3 or 5
off
Attention, your Communicator
call is being number.......... is calling .
terminated.
Achtung, das Es ruft das
Gespräch wird Notruftelefon
beendet. Nummer......an.
due to poor
Confirmation
message. Parameter
975 last digit = 5
off
Connection
confirmed.
63/78