Axis 2N Analog Force Installation Manual page 56

Frequently Asked Questions About Keypad Function
Can any of the switches be activated permanently?
Yes, the additional switch can be activated by one password and deactivated by
another.
Is it possible to arrange for the switch to be activated during the whole call?
Yes, additional switch can do it.
Is it possible to use a single command to activate one switch first and the other
later?
Yes, it is possible to use parameter 824, Switch 2 delay.
Can both the switches be activated at the same time?
While one switch is activated, the other can be activated by another password. You
can also use parameter 824, Switch 2 delay, defining the shortest delay time possible
(1second) and a sufficiently long switch activation time.
Can I use the code lock while another person is speaking through intercom?
Yes, but this is not advisable as you should be aware that the password is private and
could contravene security.
What happens when I press a number with no pre-programmed memory while
the button replacing function is enabled?
The same as if you pressed a button that is not pre-programmed: intercom seizes the
line, beeps refusal (refer to Signalling) and hangs up immediately.
What happens if a password is identical with the memory number while the code
lock and button substituting functions are enabled?
The code lock function has the highest priority. If, for example, the password is 33 and
you press
without an asterisk, the line is seized after a preset delay and the number from
memory 33 is dialled.
2N TELEKOMUNIKACE a.s., www.2n.cz
, the switch is activated instantaneously. If you press
56/78