Axis 2N Analog Force Installation Manual page 32

Mounting Completion
Having connected all the wires, make sure that the bushings, if used, are
1.
tightened properly and the RJ-45 connector is inserted in the PCB connector (if
used).
Replace the front cover carefully. Make sure that the wires inside the device
2.
leave enough space for the front cover assembly. Tighten the four screws
thoroughly with the wrench enclosed (Torx 20) to make the panel fit tightly to
the metal chassis.
Caution
An incorrect mounting may compromise the intercom water tightness.
Water leakage may damage the electronic part of the system.
Stainless steel screws are used for the 2N
assembly. Other screws than stainless steel ones corrode soon and may
aesthetically deteriorate the surrounding environment!
2N TELEKOMUNIKACE a.s., www.2n.cz
®
Analog Force/Safety
32/78