Data Save - Yamaha PM 5000 Owner's Manual

Digital Control Section
● Format
2
If you selected FMT and pressed [ENTER] in step 1,
above, the following confirmation message should
appear.
S U R E ? Y : 1
3
Press the alpha-numeric [1] key to begin formatting
the card, or [3] to abort the operation. Never remove
a memory card from the card slot during a format
operation. The following display will appear while
the card is being formatted.
E x e c u t i n g
NOT E
CompactFlash memory cards can also be formatted using a
computer, but we recommend that you format cards using the
PM5000 format function to minimize the possibility of load
errors.
● Data Save
2
After selecting SAV and pressing [ENTER] in step 1,
above, you will need to select the type of data to be
saved (below) and then press [ENTER] to confirm.
• ALL: All PM5000 data (scene memory, setup
memory, program change table).
• SCENE: Scene memory data (scenes 010 ~ 999).
• SETUP: setup memory data (page 57).
• TABLE: The program change table data set up via
utility function parameter number U28.
3
Whatever data type you select you will need to enter
a name of up to 8 characters for the file to be saved.
Enter a name so you can easily identify the data later.
S A V : N E W _ D A T A
NOT E
File names are entered using capital letters only. The character set
available for file names is somewhat different from the set
available for scene titles (refer to the chart below). Spaces cannot
be used in file names.
60
N : 3
Number
Usable Filename Characters (selected in sequence by the number key)
Key
1 ! # $ % & ' ( ) - @
2
A B C
3
D E F
4
G H I
5 J K L
6
M N O
7
P Q R S
8
T U V
9 W X Y Z
4
When the file name has been entered press the
[ENTER] key. The following confirmation message
will appear on the display.
S U R E ? Y : 1
N OTE
If a file with the same name already exists the message will
confirm that it is OK to overwrite the existing file – "SURE" in
the above will appear as "OVWR".
5
Press the alpha-numeric [1] key to begin saving to
the card, or [3] to abort the operation. Never remove
a memory card from the card slot during a save
operation. The following display will appear while
the data is being saved.
E x e c u t i n g
● Data Load
2
After selecting LOD and pressing [ENTER] in step
1, above, you will need to select the data file you
want to load from the memory card.
L O D : Y A M A H A 0 1
3
When you have selected the file to be loaded press
the [ENTER] key. The following confirmation
message will appear.
S U R E ? Y : 1
N : 3
N : 3