Monitor Control Section - Yamaha PM 5000 Owner's Manual

Monitor Control Section

Monitor Control Section
Monitor Source
The monitor out section controls output to the consoles
two monitor outputs (MONITOR A & B OUT) as well
as to the headphone jacks.
NOT E
A monitor delay function is provided to allow a delay to be
applied to the monitor and headphone outputs for time alignment
between the sound from the main house and monitor speakers.
40
Three sources can be selected for monitoring: the stereo
master signal, input from the 2-track inputs (2TR IN 1 &
2), and CUE. The stereo master signal can be monitored
via the MONITOR A or MONITOR B output simply by
engaging the corresponding [ON] switch and adjusting
the [LEVEL] control as required. If the [2TR IN 1] or
[2TR IN 2] switch is then engaged the monitor source
will be switched to the corresponding 2-track input. Cue
monitoring occurs when any channel or master [CUE]
switch is engaged (cue monitoring takes priority over 2-
track input monitoring).
Normal
Operation
Monitor Stereo
Signal master.
N OTE
If the console is set up so that the stereo master signal is not
normally output (see page 67), only the cue signals will appear at
the MONITOR outputs.
[2TR IN 1/2] [CUE]
Engaged Engaged
2-track input. Cue