Stereo Matrix Mode - Yamaha PM 5000 Owner's Manual

Digital Control Section
3 - 4 : G R P
5 - 6 : A U X
7 - 8 : A U X
NOT E
Asterisks in the "ALL" display, as shown above, indicate that the
G/A buses are set to different modes. If all buses are set to the
same mode "GRP POST", "GRP PRE", or "AUX" will appear.
2
Use the [INC] and [DEC] keys to select GRP POST
(group stereo), GRP PRE (group mono) or AUX, and
the press the [ENTER] key. The following
confirmation message will appear on the parameter
display.
S U R E ? Y : 1
3
Press the alpha-numeric [1] key to execute the
selected operation, or [3] to abort.
NOT E
As soon as the mode change is confirmed the mode indicators on
target G/A modules will change to reflect then new mode. All
[CUE] switches will automatically be disengaged.
4
Make changes to other G/A buses as necessary.
64
P R E
N : 3
Stereo Matrix Mode (Parameter No. U08)
The L and R buses that make up the console's four stereo
matrices can also be used as mono matrices, both buses
in each pair carrying the same L+R signal. When a
stereo matrix is set for mono operation the
corresponding MONO MODE indicator in the matrix
out section will light (page 37).
M A T R I X
1
Press [ENTER] after selecting the above display and
it will become possible to select the target stereo
matrix via the parameter display: use the [INC] and
[DEC] or alpha-numeric keys to select ALL (all
stereo matrices) or the desired pair (ST1, ST2, ST3,
ST4), and then press the [ENTER] key.
A L L : * * * * * * * *
S T 1 : S T
S T 2 : M O N O
S T 3 : S T
S T 4 : M O N O
N OTE
Asterisks in the "ALL" display, as shown above, indicate that the
stereo matrices are set to different modes. If all stereo matrices
are set to the same mode "ST" or "MONO" will appear.
2
Use the [INC] and [DEC] keys to select ST (stereo)
or MONO.
3
Make changes to other stereo matrices as necessary.
M O D E