golmar KEYBUS SE Installation Manual page 9

STANDALONE
7.12.SECURITY MODES
7.12.1.SAFE MODE OFF (default value)
In case of consecutive wrong codes being introduced, no alarm is triggered.
7.12.2.SAFE MODE WITH LOCK ACTIVATED
If 10 false codes/cards are introduced within 10 minutes, the terminal will be blocked. It will not take any readings.
7.12.3.SAFE MODE WITH ALARM ACTIVATED
If within 10 minutes 10 unauthorized attempts are made(false codes/cards), the terminal emits an alarm.
It can be muted by entering the "master code" (administrator).
7.13. CHANGE MASTER CODE
Before starting to register users, it is recommended to change the
manipulation by people who do not belong to the installation.To change the code, proceed as follows.
Enter administrator mode
*
MASTER CODE
(By default: 888888)
7.14..RESET FACTORY SETTINGS
To return to the factory settings, remove the power supply of the reader, press the * key and without releasing it, after one second, it
will emit two beeps and the orange LED will light up, release the key and you will hear a long beep, at that moment the factory settings
will be restored.
IMPORTANT: Codes or recorded cards are not lost.
8.MEANING OF SOUNDS AND STATUS LEDS
OPERATION STATUS
Open lock release
Correct operation
Incorrect operation
Read card or PIN
Programming
Programming frequency
ADD card reading
DELETE card reading
www.golmar.es
Enter administrator mode
*
MASTER CODE
(By default: 888888)
Enter administrator mode
*
MASTER CODE
(By default: 888888)
Enter administrator mode
*
MASTER CODE
(By default: 888888)
#
0
NEW 6-DIGIT
MASTER CODE
Standby
Press key
Read card
PIN input
Alarm
850 #
#
851 #
#
852 #
#
master user code (factory default 888888), in order to avoid possible
#
LED COLOR
Red
Green
Green
Green
Slow flashing red
Slow flashing red
Slow flashing red
Orange
Orange
Orange
Fast flashing red
KEYBUS SE
#
REPEAT NEW
CODE
BUZZER
Short beep
Long beep
Long beep
Long beep
3 short beeps
2 short beeps
Alarm
9