Table of Contents
Advertisement
STANDALONE
9.3.SLAVE MODE WITH IP OPENER WIEGAND CONTROLLER
The reader must be set as a
Wiegand
RED
BLACK
GREEN
WHITE
BROWN
IMPORTANT:
Remember that in slave mode the reader only reads the credential. The credential must have been previously encoded
in the controller's management program.
An example is shown below on iP Opener where: a PIN code, a TAGDOOR MF+ key fob and an ISOPROX card have been encoded.
At this point, entering the registered PIN code (1315 plus #) or by approaching either of the two registered proximity credentials to the
reader will validate access.
IMPORTANT:
In case you are not familiar with the configuration of the iP Opener controllers, please refer to the quick configuration
guide or the manual.
www.golmar.es
slave: *888888# (master code) + 710#.
KEYBUS SE
YELLOW
BLUE PUERPLE ORANGE
GREY
KEYBUS SE
Door 1
Door 2
Door 1
11
Advertisement
Table of Contents
Need help?
Do you have a question about the KEYBUS SE and is the answer not in the manual?
Questions and answers