Omron Z550 Operation Manual page 89

Angle
The inclination of the workpiece is measured.
The following conditions will be used as an example for describing the setting procedures.
1.
Select [Meas set].
A list of outputs appears.
2.
Select an output for which [Angle] is set.
In this example, select [OUT1].
The selections for measurement item appear.
3.
Select [Angle].
Setting Measurement Conditions (Expert Menu)
First Second
point point
Scn 0 Set
Image
Detect set
Meas set
Extra set
Meas mode
Output
Scn 0 Set
OUT0:Height
OUT1:
OUT2:
OUT3:
OUT4:
OUT5:
OUT6:
OUT7:
Measrmnt item
Height
Step: 2 pts
Step: 3 pts
Edge position
Width
Edge center
Peak/bottom
Angle
SECTION 3
Z550
87
Operation Manual