Omron Z550 Operation Manual page 230

SECTION 6
Communication with External Devices
Timing Chart 7
Measurement mode
Trigger measurement
(External)
Measurement is performed according to the TRG signal of the terminal block, and hold
measurement is started when the measurement result matches with the trigger conditions.
Assuming the measurement duration is specified to three times the measurement time (*1)
OFF
TRG
ON
of terminal block
Image acquisition
Calculation
processing
Terminal block output (*2)
Analog output
(OUT for which hold is set)
Terminal block output
Analog output
(OUT for which no hold is set)
GATE output OFF
ON
PROFILE data
(sent by Controller)
RUN output OFF
ON
BUSY output OFF
ON
*1 Specify the measurement duration to 200 ms when the measurement time is 100 ms in order to set it
to three times the measurement time.
*2 ALL-PASS and ERROR outputs are always output at the timing when "hold" is set.
Z550
228
Operation Manual
Hold&Logging
Hold (Self)
Measurement This result matches with
time the trigger condition.
Output value according to the hold setting
GATE GATE
ON delay ON time