C Setting Segment Programs - Omron WS02-LCTC1-EV5 - V5.2 REV 12-2008 Manual

A special input interface is provided for setting program patterns and bank data for Segment Program 2 (Block
Model 157) and Segment Program 3 (Block Model 158) blocks.
This section describes how to set individual parameters from the CX-Process Tool. For details on block function
specifications and functions, and information on specific operations, refer to the Loop Control Board Function
Block Reference Manual.
Setting Segment Program 2 Blocks
Use the following method to set the program pattern.
1. Open the Segment Program 2 ITEM list, right-click in the ITEM list, and select Extension from the pop-up
menu.
2. The Edit Segment Program 2 Parameters Window will be displayed.
The contents of the ITEMs for each step will be displayed in table format. When the table is directly edited and the
OK Button is pressed, the values will be reflected in the function block ITEMs. (For details on the editing function,
refer to Edit Window Functions.)
The items in the Edit Window are as follows:
Horizontal Axis
1 to 30: Step numbers
Vertical Axis
Time width (A): Used to set the time width as A.
Output value (B): Used to set the output value as B. The value will be displayed in engineering units if the
Engineering Unit Mode is set.
Wait width: Used to set the wait width. The value will be displayed in engineering units if the Engineering
Unit Mode is set.
Appendix C
Setting Segment Programs
329