Version 1.50 - Omron WS02-LCTC1-EV5 - V5.2 REV 12-2008 Manual

Version Improvements

1-4-2 Version 1.50

Item
Function blocks that can
be created
Printing functions
Monitor tag list display
function
Search function
Version check function
16
The improvements made from version 1.20 to version 1.50 of the CX-Process
Tool are as follows:
Ver. 1.20
Not compatible with
Loop Control Unit Ver.
1.50
Except for function
blocks, only open block
diagrams, ladder
diagrams, and
cross-references can be
printed.
None
None
None
Compatible with the creation of following new function blocks with
the Ver. 1.50 Loop Control Units: Segment Program 2 (Block
Model 157), Accumulated Value Input Adder (Block Model 182),
Accumulated Value Input Multiplier (Block Model 183), Constant
Comparator (Block Model 202), Variable Comparator (Block
Model 203), Clock Pulse (Block Model 207), ON/OFF Valve
Manipulator (Block Model 221), Motor Manipulator (Block Model
222), Reversible Motor Manipulator (Block Model 223), Motor
Opening Manipulator (Block Model 224)
Compatible with the following new Loop Control Unit Ver. 1.50
ITEM creations: AT (auto-tuning) functions of Basic PID block
(Block Model 011) and Advanced PID (Block Model 012), and
wait function and additional steps (step numbers 8 to 15) of the
Ramp Program block (Block Model 155)
• You can print block diagrams, ladder diagrams, and cross-refer-
ences by LCU element or node, even if they are not open.
• You can print monitor tag lists.
• You can print all data by LCU element or node.
Possible (displays the monitor software tag information that has
been set)
Possible (searches for block address or monitor software tag
name, and moves the cursor to the matching function block)
Possible (checks for version compatibility between the Loop
Control Unit connected online and CX-Process Tool in use)
Section
Ver. 1.50
1-4