Omron WS02-LCTC1-EV5 - V5.2 REV 12-2008 Manual page 284

Downloading, Uploading and Comparing Data
Upload New
1, 2, 3...
Upload Previous
1, 2, 3...
To upload a new function block file, create the new function block file by taking
the following steps 1 and 2 or insert LCU/LCB element data in the existing file
and begin with step 3.
1. Select New from the File Menu.
2. Create a multi-node folder.
3. Select Insert – Insert Node from the Settings Menu and input the LCU/LCB
element name (LCB01, LCB03, LCB05, LCB05D, LC001-1 to LC001-3).
4. Select Network Settings from the Settings Menu to set the network ad-
dress and node address.
5. Select the LCU/LCB element. Select Transfer from LC – New from the
Execution Menu.
The following dialog box will appear.
6. Click the OK Button.
The following dialog box will appear.
Note Here, data on the Edit Block Diagram Screen (function block information) will be
lost and the block diagram showing the connections between function blocks will
not be displayed. To display the block diagram, connect the function blocks
again after the function block file is uploaded.
7. Click the OK Button.
8. Click the Start Button. The uploading of the new function block file will start.
A dialog box will appear while the new function block file is uploaded.
9. The box will be closed automatically when processing is completed.
1. Open the existing file of function block data in the Loop Controller.
2. Compare the file and the function block data in the Loop Controller.
a) Select the LCU/LCB element or the function block to be refreshed. Se-
lect Compare from the Execute Menu.
Section 4-3
259