Omron VARISPEED G7 Instruction Manual page 328

Name
Con-
stant
Display
Number
STOP key dur- Sets the Stop Key in the run
ing control cir- mode.
cuit terminal 0: Disabled (When the run
operation
o2-02
Oper STOP
1: Enabled (Effective even
Key
User constant Clears or stores user initial values.
initial value 0: Stores/not set
1: Begins storing (Records the
o2-03
2: All clear (Clears all recorded
User Defaults
When the set constants are
recorded as user initial values,
1110 will be set in A1-03.
Frequency ref- When the frequency reference is
erence setting set on the Digital Operator fre-
method selec- quency reference monitor, sets
tion whether the Enter Key is neces-
sary.
o2-05
0: Enter Key needed
1: Enter Key not needed
Operator
When set to 1, the Inverter
M.O.P.
accepts the frequency reference
without Enter Key operation.
Cumulative
Sets the cumulative operation
operation time
time in hour units.
setting
o2-07
Operation time is calculated from
Elapsed Time
the set values.
Set
Fan operation
Set the initial value of the fan
time setting
operation time using time units.
o2-10
The operation time accumulates
Fan ON Time
from the set value.
Set
Changing Frequency Reference and Display Units
Set the Digital Operator frequency reference and display units using constant o1-03. You can change the units
for the following constants using o1-03.
U1-01 (Frequency Reference)
•
U1-02 (Output Frequency)
•
U1-05 (Motor Speed)
•
U1-20 (Output Frequency after Soft Start)
•
d1-01 to d1-17 (Frequency references)
•
Switching Monitors when the Power Supply Is ON
Using constant o1-02, select the monitor item (U1-
ator when the power supply is turned ON. For monitors that can be displayed, refer to U1-
User Constants.
Setting
Description
Range
command is issued from and
0 or 1
external terminal, the Stop
Key is disabled.)
during run.)
set constants as user initial
values.)
0 to 2
user initial values)
0 or 1
65535
65535
Change
Factory during
Setting Opera-
V/f
tion
1 No A
0 No A
0 No A
0 to
0 hr No A
0 to
0 hr No A
[status monitor]) to be displayed on the Digital Oper-
Digital Operator Functions
Control Methods
Open Open
V/f Flux
Loop Loop
with Vec-
Vector Vector
PG tor
1 2
A A A A
A A A A
A A A A
A A A A
A A A A
in Chapter 5
6-
133