Return To The Normal Operation Mode - Omron V640 - MANUAL 2 User Manual

SECTION 3
Preparing for Communications
2.
Confirm the parameter change.
The input parameter is checked and written.
■ Check for Correct Setting
The currently set data can be output so that you can check if it is correct.
1.
Send the parameter output command "::GET_VER" from
the host device.
The software revision settings are displayed.

Return to the Normal Operation mode

■ When the Mode is Selected with the Mode Switch on the Bottom of the Unit
1.
Turn OFF the power to the CIDRW Controller.
2.
Set the mode switch on the bottom of the unit to
the 0.
3.
When all of the devices to be used are connected, turn the power ON.
Start up in the Normal Operation mode.
Even if you restart with the mode switch left at the 3 position, or send a reset command "::EXIT," the Controller will start
in the Setting mode. To switch to Normal Operation mode, you must set the mode switch to 0.
■ When the Mode is Selected by a Command Sent from the Host Device
1.
Either send the reset command "::EXIT" from the host
device or turn the power to the CIDRW Controller OFF
and then back ON.
Start up in the Normal Operation mode.
CIDRW System
58
User's Manual
::END
_
::GET_VER
RVER=1.10
::END
_
7
0
::EXIT
_