Omron TJ1-MC04 - PROGRAMMING 1 Programming Manual page 273

Examples and tips
'(SCOPE_POS=1000)
'- We have the permission (VR(activate_trigger)=ON)
IF SCOPE_POS=1000 AND VR(activate_trigger)=ON THEN
TRIGGER
PRINT "Triggered"
ENDIF
WAIT IDLE
WEND
HALT
To view the capture result in the oscilloscope of Trajexia Tools, you
must make the settings in the Oscilloscope Configuration
window as given in the figure.
You must also disable further capturing to avoid mixing the results
of two different captures in the same Table memory entries.
PROGRAMMING MANUAL
fig. 44
273