Toolbar - Omron TJ1-MC04 - PROGRAMMING 1 Programming Manual

Trajexia Tools interface
5.4.3

Toolbar

/i
Connect Connects the Trajexia Tools to the Trajexia
system. Refer to Connect in "Controller
menu" (p. 198).
Disconnect Disconnects the Trajexia Tools from the Tra-
jexia system. Refer to Disconnect in the
menu "Controller menu" (p. 198).
Terminal Command line editor. Refer to Terminal in
the "Tools menu" (p. 205).
Axis Refer to Axis parameters in the "Tools menu"
Parameters (p. 205).
Intelligent Refer to Intelligent drives in the "Tools menu"
drives (p. 205).
Oscilloscope The software oscilloscope can be used to
trace axis and motion parameters. This
helps to program development and system
commissioning. Refer to oscilloscope in the
"Tools menu" (p. 205).
Keypad Not implemented in Trajexia.
Jog Axis This window allows the user to manually
move the axes on the Trajexia. Refer to Jog
Axis in the "Tools menu" (p. 205).
Digital IO Refer to Digital IO Status in the "Tools menu"
(p. 205).
Analog input Refer to Analog input in the "Tools menu"
(p. 205).
PROGRAMMING MANUAL
TABLE Refer to the TABLE and VR values in the
values "Tools menu" (p. 205).
VR values. Refer to the TABLE and VR values in the
"Tools menu" (p. 205).
Watch Not implemented in Trajexia.
variables
Simulator Not fully implemented in Trajexia.
Trajexia Opens Trajexia Tools Help.
Tools Help
Trio BASIC Opens Trio BASIC Help.
Help
195