System Settings - Omron CX-DESIGNER - INTRODUCTION GUIDE Introduction Manual

Start up Creating a
CX-D new project

6. System settings

6. System settings
Click
[System]
In the "Project
Workspace".
Double-click
[System Setting].
Allocate a word to
Allocate a word to
the PLC for controlling
the PLC for controlling
screen No.
screen No.
Click the [Initial] tab
Click
Set as follow:
Host name
! [HOST 1]
Word
! "0"
Area Type
! [Data Memory (DM)]
Set address in the same
way as [Set(1)]
Host name
! [HOST 1]
Word
! "10"
Area Type
! [Data Memory (DM)]
Project System
property setting
Allocating NS system memory areas to the PLC.
System memory area is memory area that is used to control the NS from the
host (PLC) or to notify operation status from the NS to the host.
In this manual, you will allocate system memory areas to the PLC.
With this setting, a present
With this setting, a present
value of DM0010CH is shown
value of DM0010CH is shown
on the PT.
on the PT.
Creating
Validation
a screen
Complete
Transferring
a project