Omron CX-DESIGNER - INTRODUCTION GUIDE Introduction Manual page 92

Start up Creating a
CX-D new project
The Power Supply (1
to 3) bit lamps will lit
by turning ON the
ON/OFF buttons.
You can check that
the addresses of the
Power Supply (1 to 3)
is turned ON on the
Test Tool dialog.
Click the Screen 2.
Click the Virtual Alarm
Display.
Project
property
[Confirming a movement of ON/OFF buttons and bit lamps of "Power Supply 1 to 5".]
[Check the ON/OFF buttons and bit lamps of Alarms.]
System Creating
setting a screen
Transferring
Validation
a project