Advantage Controls MegaTronMT Installation Maintenance Repair Manual page 27

5.4 History
This menu is used to set the history "time stamp" interval, the water meter daily history starting hour, the
alarm delay period and the USB history save format.
5.5 Flow Switch
This menu allows the user to select if a flow switch signal will represent a flowing condition when a "closed"
or "open" signal is seen for each systems flow switch input. Users can also select if timers can work always
or only with flow.
5.6 Temperature Scale
This menu is used to select the type of temperature scale to display.
5.7 Network
The Network menu is used when a controller is being remotely communicated with either a local network
connection or over the internet on the WebAdvantage server. IP Address, IP Mask, Gateway, and other
information can be viewed from this menu.
5.8 System Information
System information will identify the version of firmware installed in the controller along with the controller's
serial number.
INTERVAL - The amount of time between each
history time stamp for probe readings.
W/M HOUR - The time of day that the daily water
meter history cycle is to start.
ALARM DELAY - The amount of time an alarm has to
be on before it is recognized as an alarm.
SAVE FORMAT - The USB history save format.
SETTINGS - This menu is used for setting up the
remote WebAdvantage communications and is
covered in a separate manual.
http://www.advantagecontrols.com/downloads/pdf/M-WebAdvantage.pdf
Note: The Network card must be RESET after making any
changes to Network setting in order to save changes and
reset communications.
27