Table of Contents
Advertisement
5. Select Print test pattern.
To print the test pattern on an envelope, place an envelope of the feed deck and select
l
Start.
To print the test sample on tape, select Tape.
l
6. Check the test pattern.
If the solid lines of the test pattern are unbroken, select Image is OK - Done. Skip to step 7.
l
If the test pattern has missing or incomplete lines, select Not OK - Clean print head. Once
l
the cleaning operation completes, you will be prompted to print another test pattern. If the
pattern still has broken or missing lines, you may need to replace the ink cartridge or print
head.
7. Select the Home button to return to the Home screen.
Installing a new tape roll
The meter uses gummed or adhesive tape. A red stripe appears along its edge approximately 914 mm
from the end to indicate a low tape condition. Replace the tape when the stripe appears. You can
install a new roll before the meter actually runs out of tape.
Important : If you do not use Pitney Bowes supplied tape, you will not be able to determine when the
tape is running out and this may cause a jam. The red stripe on the tape notifies you that you are
running low on tape. There is also a black stripe that tells the meter when it is out of tape. When the
meter detects the black stripe on the tape it stops the meter. At this point there is still a small amount of
tape on the roll.
1. Select Settings under Mailing on the Home screen.
2. Select Hardware.
3. Select Tape.
4. Select << Rewind to bring the tape back for removal.
Pitney Bowes
User Guide
April 2024
Maintenance
51
Advertisement
Table of Contents
