Maintenance; Installing A New Tape Roll - Pitney Bowes Connect+ Series Operator's Manual

Installing a new tape roll

The mailing system uses gummed or adhesive tape. A red stripe appears along its edge approximately
36 inches from the end to indicate a low tape condition. Replace the tape when the stripe appears. You
can install a new roll before the system actually runs out of tape.
Caution:
If you do not use Pitney Bowes supplied tape, you will not be able to determine when the
tape is running out and this may cause a jam. The red stripe on the tape notifies you that
you are running low on tape. There is also a black stripe that tells the machine when it is
out of tape. When the system detects the black stripe on the tape it stops the machine. At this point there
is still a small amount of tape on the roll.
1. Select the Settings button in the Mailing tile on the Home screen.
2. Select Hardware.
3. Select Tape.
4. Select << Rewind to bring the tape back for removal.
5. Open the supplies cover.
Pitney Bowes Operator Guide February, 2018

Maintenance

Page 244 of 349