Equaliser; Mode; Release Time; Example Configuration - TechniSat DIGITRADIO 22 Operating Instructions Manual

[Switch off]
Automatically dims the display to Low after the selected time. Press the
TUNE/OK rotary knob to save a setting.
Select [Always on] so that the display is not dimmed during operation
and standby.

12.5 Equaliser

The equaliser provides you with presets to improve the sound reproduction.
Select [EQ] in the MENU and press the TUNE/OK knob.
>
Use the TUNE/OK rotary knob to select a preset and press the TUNE/OK
>
rotary knob to save it.
12.6 Bew egungsmelder
The DIGITRADIO 22 can be configured so that the motion detector activates the
radio, the ambient light or both when you approach the radio.
Select the [Motion detector] entry in the MENU and press the
>
TUNE/OK rotary knob. Select the following options:

12.6.1 Mode

Under [Mode], you can specify what should happen when motion is detected by the
motion sensor:
Off:
LED:
Radio:
LED and radio:
12.6.2

Release time

You can use the trigger time to determine the delay from motion detection until the
configured function is triggered. You can select a time from 1 second to 60 seconds.
12.6.3 Runtime
The runtime determines how long an active function remains activated after the last
motion detection until it is automatically switched off again.
You can select a time from 1 minute to 10 minutes.
12.6.4

Example configuration

You have selected the LED and radio mode with a trigger time of 4 seconds
and a runtime of 3 minutes. If the motion detector detects movement, e.g. when
you go into the kitchen, the ambient light and radio are switched on after 4
seconds. After 3 minutes (if no
movement is detected), the light and radio are switched off again.
26
Motion detector is inactive
Ambient light is activated
The radio is switched on
Radio and light are switched on