Installing The Digitradio 22 - TechniSat DIGITRADIO 22 Operating Instructions Manual

5 Installing the DIGITRADIO 22

Notes:
- Do not install or place the appliance near heat sources such as radiators.
Avoid direct sunlight and places with an unusually high level of dust.
- The location must not be selected in rooms with high humidity, e.g. sauna,
bathroom, as condensation can damage the device. The appliance is
intended for use in a dry environment and in a temperate climate and must
not be exposed to dripping or splashing water.
- Keep the DIGITRADIO 22 away from devices that generate strong
magnetic fields.
> Remove the mounting plaGe from the housing of the DIGITRADIO 22 by pulling
the plaGe backwards.
> Fasten the mounting plate under the mounting surface (e.g. a kitchen cabinet)
using the screws supplied. Note the length of the mounted thread (of the short
screws) of 13 mm. If the thickness of the wooden cabinet is thinner, use
correspondingly shorter screws.
The screws supplied can be used for wooden furniture/cupboards.
Depending on the cabinet, the spacer sleeves and the longer screws can
be used.
> Check that the mounting plate is firmly seated before attaching the DIGITRADIO
22 to the mounting plate.
> Connect the USB power cable to the power adapter supplied.
10
Mounting surface (e.g. kitchen cupboard)
Assembly plaGe
Screws