Card Reader Board Cable - HP ENVY x360 Series Maintenance And Service Manual

Card reader board cable

NOTE: The card reader board cable is available using spare part number L53535-001.
Before removing the card reader board cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
Remove the card reader board cable:
1. Release the ZIF connector (1) to which card reader board cable is connected, and then disconnect the card
reader board cable from the system board.
2. Release the ZIF connector (2) to which card reader board cable is connected, and then disconnect the card
reader board cable from the switch board.
3. Remove the card reader board cable (3).
Reverse this procedure to install the card reader board cable.
Bottom cover on page
Battery on page 30).
28).
Component replacement procedures 43