Table of Contents
Advertisement
INSTRUMENTS
30
When the ignition switch is
turned to the ON position, it is normal
that the ABS warning light will be
illuminated. The light will remain on until
the motorcycle first reaches a speed
exceeding 6 mph (10 km/h) when it will
go off.
The warning light will not illuminate
again until the engine is restarted
unless there is a fault, or the ABS is
disabled by the rider (off-road mode for
Scrambler 400 X only).
Scrambler 400 X only: If the ABS is
disabled by the rider (off-road mode),
the warning light will remain illuminated
until the ABS is enabled again.
If there is a fault with the ABS system
the warning light will be illuminated and
the general warning symbol will flash.
Traction Control (TC) Indicator Light
The
Traction
indicator light is used to indicate that
the traction control system is active and
is working to limit rear wheel slip during
periods of hard acceleration or under
wet or slippery road conditions. Traction
control will not function if there is a
malfunction with the ABS. The warning
lights for the ABS, traction control and
the MIL will be illuminated.
WARNING
If
the
traction
functioning, care must be taken when
accelerating and cornering on wet/
slippery road surfaces to avoid rear
wheel spin. Do not continue to ride for
longer than is necessary with the
engine
management
Malfunction Indicator Light (MIL) and
traction
control
illuminated.
The fault must be checked and
rectified by a competent person with
the specialist knowledge and technical
understanding of motorcycles, such as
an authorised Triumph dealer.
Hard acceleration and cornering may
cause the rear wheel to spin, leading
to loss of motorcycle control which
could result in serious injury or death.
Control
(TC)
control
is
not
system
warning
lights
Advertisement
Chapters
Table of Contents
