Dascom DC-8600 User Manual page 78

Dascom DC-8600
Display
Film Jam Probable Cause: Retransfer film winding problem.
Action: Do not turn off power. Refer to Section 2.3 to reload the retransfer film.
Press Right Key to clear this warning and the printer will resume previous
printing after initialization.
Ribbon Jam Probable Cause: Ribbon winding problem.
Action: Do not turn off power. Refer to Section 2.2 to reload the ribbon. Press
Right Key to clear this warning and the printer will resume previous printing
after initialization.
Feeder Card Pressing SET as LCD display shown may eject jammed card after initialization.
Jam
If the fault is not cleared after initialization, turn the rollers manually to clear
jammed card
Flip Card Jam Pressing SET as LCD display shown may eject jammed card after initialization. If
the fault is not cleared after initialization, turn the rollers manually to clear
jammed card
Do not turn off power. Open the front cover. Turn the rollers to clear jammed
Printer Card
card. Close the front cover. Press Right Key to clear this warning and the printer
Jam
will resume previous printing after initialization。
Magnetic Card
Pressing SET as LCD display. The error may be corrected after initialization
Jam
and printing resumes. If initialization cannot clear the fault, manually turn the
rollers to clear jammed card.
Heating
Wait for the printer to warm up to its operating temperature.
RFID_AUTH_E Check if genuine ribbon is used. Next, check if the ribbon has an RFID ring.
RROR Press Right Key as the LCD shown to initialize the printer.
Call Support Contact your reseller's service support team to report Error Code(s) displayed
on the lower right.
Contact your reseller's service support team if you find errors not listed
above. Please inform Error Code displayed on the lower right of the LCD.
Solution
65
User Guide V1.0