Table of Contents
Advertisement
Handpiece Vacuum/Pressure
NOTE: The Air Hose and Slide Rod must be positioned to prevent any kinking of the hose. Kinks in
the hose will prevent proper airflow when the system is operated and will cause a
deterioration in performance.
Corrective Maintenance
Listed below are message codes which may be displayed on the Digital Readout if a mistake is made by
the operator (e.g., wrong password entry) or if the system has malfunctioned.
Display Error Message
Wrong Password
Open Sensor
Blower Run Error
Power Source/Handpiece
Refer to the table below. Most malfunctions are simple and easy to correct.
Symptom
No power to system
Heater Assembly does
not heat. No
malfunction indicated
on Digital Readout.
Little or no air flow,
heater heats and
blower is running
Display on Digital
Readout indicates a
malfunction.
Little or no vacuum
Vacuum Cup will not
hold component
Vacuum Pickup Rod
binding
©2013 PACE Inc., Southern Pines, NC
All Rights Reserved
Description
The incorrect Password has been entered. The
displayed message will time out after 3 seconds and
revert to normal operation. Enter the correct
Password.
The heater assembly sensor is open.
Replace heater assembly.
The power source blower unit is not running. Contact
PACE for assistance.
Probable Cause
Solution
Blown Fuse
Inspect and replace the fuse(s) located on the
power source rear panel.
Line cord
Plug line cord into the appropriate AC outlet.
unplugged
Open Heater
Contact PACE for assistance.
Kinked air hose
Change routing of air hose to remove
kinks.
Refer to Display Error Messages.
Worn vacuum
Replace vacuum pump. Contact PACE for
pump
assistance.
Worn or broken
Replace vacuum cup.
vacuum cup
Vacuum Pickup
Refer to the Vacuum Pick Replacement manual.
rod is bent
Page 28 of 31
Advertisement
Table of Contents
