Installation - Mono FG174 Manual

4.0 INSTALLATION

POWER (uk versions)
4/5 TRAY OVENS - 415 volts. 3 PHASE, + NEUTRAL + EARTH, 50HZ
10 TRAY OVENS - 415 volts. 3 PHASE, + NEUTRAL + EARTH, 50HZ
POWER (export versions)
4/5 TRAY OVENS - 400 volts. 3 PHASE, + NEUTRAL + EARTH, 50HZ
The supply to this machine must be protected by a 30mA RCD
WATER
¾" B.S.P. Flexible hose.
WATER PRESSURE 2 bar – 4 bar
Domestic pressure is usually within this parameter.
Water conditioning unit advised, especially in hard water areas.
It is the customers' sole responsibility to arrange adequate ventilation and it should be
1.
sufficient to ensure water does not condense on or around the oven. A 50mm gap is
recommended at the sides and rear of this oven and 250mm above.
2. Chimneys and evacuation ducts fitted above mono ovens should be insulated to stop
condensate flowing back into the oven.
3. Water connection should be to a suitable clean water supply,
making sure that the pipes are flushed out to remove all
foreign bodies i.e. flux or solder.
Customers in hard water areas must ensure that an efficient
water treatment device protects the supply to the oven.
It is the customers' responsibility to install and maintain an
adequate water supply to the oven, which should comply with
local water regulations.
In the UK a backflow prevention device must be fitted.
Bx oven Nonwash Eco 60 x 40 RevA20 8-1-20
11amps per phase, total power 7.5kW
(element = 7kW 240v stainless steel)
21amps per phase, total power 15kW
(element = 7kW 240v stainless steel x2)
12amps per phase, total power 7.5kW
(element = 7kW 220v stainless steel)
OVEN WATER CONNECTION
AT REAR
9