Advance Function; Mcast - Fanvil i66 User Manual

6

Advance Function

6.1

MCAST

This feature allows user to make some kind of broadcast call to people who are in
multicast group. User can configure a multicast DSS Key on the phone, which allows user
to send a Real Time Transport Protocol (RTP) stream to the pre-configured multicast
address without involving SIP signaling. You can also configure the phone to receive an
RTP stream from pre-configured multicast listening address without involving SIP
signaling.
Users can configure multicast listening address and port on the web page of [Intercom
Settings]>> [Multicast].
Configuration parameters:
Parameters
Priority
Mcast Listening Renew
Time(s)
Multicast prompt Tone
Enable Prio Chan
Enable Page Priority
Enable Emer Chan
Name
Host:port
Channel
MCAST Dynamic：
Description: send multicast configuration information through SIP notify signaling. After
receiving the message, the device configures it to the system for multicast monitoring or
Description
Defines the priority in the current call, with 1 being the highest
priority and 10 the lowest.
Set the interval for re-listening to multicast after interrupting
the listening.
When enabled, play the prompt sound when receiving
multicast.
When enabled, the same port and channel can only be
connected. Channel 24 is the priority channel, higher than
1-23; channel 0 means not to use the channel.
Regardless of which of the two multicast groups is called in
first, the device will receive the higher priority multicast first.
When enabled, channel 25 has the highest priority.
Set the multicast name.
Set the multicast server address and port.
0-25 (24: Priority Channel, 25: Emergency Channel).
22