Table of Contents
Advertisement
Before using for the first time
Setting the water hardness level
Contact your local water supplier to
find out the hardness of the water in
your area.
More information can be found under
"Settings – Water hardness".
Select your local water hardness on
the appliance.
Confirm with OK.
Completing the commissioning
process
Follow any further instructions in the
display.
The oven is now ready for use.
Switching on furniture front detection
If the combination steam oven was built
in behind a furniture front (e.g. a door),
furniture front detection must be
switched on.
Select
|
Settings
|
.
recognition
On
36
Furniture front
Cleaning the combination
steam oven for the first time
Remove any protective foil and
stickers, with the exception of the
data plate and the small plate on the
opened control panel, from the
combination steam oven and
accessories.
The combination steam oven is
subjected to a functional test at the
factory, which means that residual
water from the pipes may run back into
the oven compartment during
transportation.
Cleaning the water container and
condensate container
Risk of injury caused by control
panel.
You could get caught in the control
panel as it opens or closes.
Do not touch the upper edge of the
door when the control panel is
opening and closing.
Use the On/Off sensor control to
switch the combination steam oven
on.
Select the sensor control to open
the control panel.
Remove the water container and
condensate container. To do this,
push the water container and
condensate container upwards
slightly.
Rinse the water container and
condensate container by hand or in
the dishwasher.
Advertisement
Table of Contents
