Table of Contents
Advertisement
Before using for the first time
Setting the water hardness level
Contact your local water supplier to
find out your local water hardness
range if necessary.
See the "Settings - Water hardness"
for more information.
Set the water hardness level for your
area.
Confirm with OK.
Completing the commissioning
process
Follow any further instructions in the
display.
The appliance is now ready for use.
Switching on furniture front detection
If the steam combination oven was built
in behind a furniture front (e.g. a door),
furniture front detection must be
switched on.
Select
|
Settings
|
.
recognition
On
36
Furniture front
Cleaning the steam
combination oven for the first
time
Remove any protective foil and
stickers, with the exception of the
data plate and the small plate on the
opened control panel, from the steam
combination oven and accessories.
The steam combination oven is
subjected to a functional test at the
factory, which means that residual
water from the pipes can run back into
the oven compartment during
transportation under some
circumstances.
Cleaning the water container and
condensate container
Risk of injury caused by control
panel.
You could get caught in the control
panel as it opens or closes.
Do not touch the upper edge of the
door when the control panel is
opening and closing.
Switch the steam combination oven
on with the On/Off sensor.
Select the sensor to open the
control panel.
Remove the water container and
condensate container. To do this,
push the water container and
condensate container upwards
slightly as you take them out of the
appliance.
Rinse the water container and
condensate container by hand or in
the dishwasher.
Advertisement
Table of Contents
