General Problems Or Technical Faults - Miele 12 209 990 Operating And Installation Instructions

Combination steam oven
Table of Contents

Advertisement

Problem solving guide

General problems or technical faults

Issue
The combination steam
oven cannot be
switched on.
The oven interior lighting
is not working.
The control panel will
not open or close
automatically despite
touching the  sensor
several times.
162
Cause and remedy
The circuit breaker has tripped.
 Reset the trip switch in the circuit breaker box (see
data plate for minimum protection rating).
There may be a technical fault.
 Disconnect the combination steam oven from the
electrical supply for approx. 1 minute by:
– Tripping the relevant mains fuse or unscrewing
the fuse completely, or
– Switching off the residual current device
 If, after resetting the trip switch in the mains fuse
box or the residual current device, the combination
steam oven will still not turn on, contact a qualified
electrician or your Miele dealer.
The lamp is defective.
 Contact your Miele dealer to have the lamp
replaced.
Something is obstructing the control panel.
 Remove the obstruction.
The obstruction sensor is very sensitive and can
prevent the panel opening or shutting if it picks up a
signal.
 Open/close the control panel manually (see end of
this section)
 If the problem occurs again, contact your Miele
dealer.

Advertisement

Table of Contents
loading

Table of Contents